|
Residential / Commercial Providing San Diego with affordable electrical and solar services for 36 years |
![]() |
|
|
Energy Efficiency - CorCoolCCS™ HOW CorCoolCCS™ WORKS CorCoolCCS™ indirect pre coolers are installed around your A/C system in a manner that encapsulates the system in its own microclimate. Then cool, dry air is created that allows your A/C system to operate as if it is 80-85° F outside even when it is well into the 100s. Your A/C system will operate at its highest possible efficiency and lowest possible power consumption. CorCoolCCS™ is system friendly and will not damage your A/C system in any way. To understand how an indirect evaporative system works, imagine hot air being blown through a pipe on a hot, dry day. Now spray water over this hot pipe. What happens to this hot air being blown into the pipe? It will come out of the pipe much cooler, however, it isn’t wet……its cool, dry air. It is as simple as that! CorCoolCCS™ is so unique, however, that it is protected by patents and worldwide patents pending. The picture below shows a CorCoolCCS™ with nominal dimensions. Dimensions may vary depending on location of the existing condenser system.
Benefits You'll See When You Add CorCool to an Existing A\C Unit:
Beware of Cheap Imitations Attempts have been made to sell direct wet matt methods to cool condensers. These systems use cellulose material that is saturated with water. While this approach may seem to be a good idea at first, these systems will carry mineralized water on to the A/C unit destroying the fins, stopping the system from operating properly, and negating any warranties. Make sure the system you chose is not a direct system….make sure its an indirect CorCoolCCS™ dry air pre cooler.
Here’s What’s Happening Inside Your A/C System
This means that by installing CorCoolCCS™ around a 10 SEER A/C system you will save more than by upgrading to an 18 SEER A/C system at a fraction of the cost!
Email us today to get a
free evaluation of your cooling situation.
|
||